The short version of prohibited list fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-07-01 and is reviewed periodically as new material appears.
No major regulatory agency has approved TB-500 for therapeutic use, and it holds no pharmacopoeial monograph. The name appears on the World Anti-Doping Agency prohibited list within the class covering peptide hormones, growth factors, and related substances. Detection in doping control relies on mass spectrometric methods applied to urine, often after preparation steps that concentrate the analyte. Discussion of TB-500 therefore clusters in biochemistry, sports medicine, and anti-doping literature rather than in registered clinical trials.
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
| Property | Value | Notes |
|---|---|---|
| Molecular mass | Approximately 4963 Da for full-length thymosin beta-4 | Value applies to the parent protein; fragment products may differ |
| Appearance | White to off-white lyophilized powder | Typical form of supplied synthetic peptide |
| Solubility | Freely soluble in water | Polar peptide; dissolves readily in aqueous buffer |
| Storage of dry powder | −20 °C, desiccated, protected from light | Standard laboratory practice for peptides |
| Typical detection method | Liquid chromatography–tandem mass spectrometry | Used in purity testing and anti-doping analysis |
Detection in biological matrices generally relies on liquid chromatography coupled with tandem mass spectrometry, because the peptide lacks a convenient ultraviolet chromophore beyond the amide backbone. Immunoassays have been described, but antibodies raised against the fragment can cross-react with the full-length protein or with unrelated peptides, so findings usually require confirmation by a second technique. Sample preparation typically involves protein precipitation followed by solid-phase extraction. Reported detection windows depend on dose, route, matrix, and instrument sensitivity.
Lyophilised material is stable for extended periods when kept dry and cold, and suppliers typically recommend storage well below freezing. Once dissolved, the peptide is handled at refrigeration temperatures and used within a short period, because peptide bonds and the acetylated terminus can be affected by repeated freeze-thaw cycles, proteases, or extreme pH. Bacteriostatic water and saline are both described as solvents, although preservatives can interfere with some analytical workflows. Reconstituted solutions are inspected for particulates before use.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
The 16-bit A register is the primary arithmetic and logic accumulator. The 16-bit B register is used for double-length arithmetic operations. The 16-bit program counter holds the address of the next instruction. A carry flag indicates arithmetic overflow. A 16-bit X index register provides for modification of the address of operands. The instruction set has 72 arithmetic, logic, I/O and flow-control instructions. Input/output instructions use the A register and separate input and output 16-bit buses. A 10-bit I/O control bus, consisting of 6 bits of device address information and 4 bits of function selection, is used. The basic processor has a single interrupt signal line, and an option provided up to 48 interrupts. In addition to a front-panel display of lights and toggle switches, the system supports different types of input/output devices. A Teletype Model 33 ASR teleprinter can be used as a console I/O device and (in the most basic systems) to load and store data to paper tape. Smaller systems typically use a high-speed paper-tape reader and punch for data storage. The Honeywell family of peripherals included card readers and punches, line printers, magnetic tape, and both fixed-head and removable hard disk drives. A rack-mounted configuration weighs around 120 pounds (54 kg) and used 475 watts of power. Honeywell advertised the system as the first minicomputer selling for less than $10,000. The Honeywell 316 has the distinction of being the first computer displayed at a computer show with semiconductor RAM memory.
== PNA translation from other nucleic acids == Several labs have reported sequence-specific polymerization of peptide nucleic acids from DNA or RNA templates. Liu and coworkers used these polymerization methods to evolve functional PNAs with the ability to fold into three-dimensional structures, similar to proteins, aptamers and ribozymes.
==== Structure ==== There are three structural zones in articular cartilage including a superficial tangential zone, a middle transitional zone and a deep zone. In the tangential zone, collagen fibers are aligned parallel to the surface and become gradually randomly aligned while moving into the deep zone. Collagen fibers in the superficial zone are aligned parallel to the surface in order to restrict shear stresses. Similarly, collagen fibers are aligned perpendicular to the surface in the deep zone in order to restrict compressive forces. Between bone and the deep zone lies calcified cartilage. Cell arrangement also varies between the zones, in deeper zones chondrocytes are stacked into columns while in the superficial zones they are arranged randomly. In the superficial regions the cells are also more elongated, while in deeper zones they are more spherical in nature.
Protein import into mitochondria Hundreds of proteins encoded by the nucleus are required for mitochondrial metabolism, growth, division, and partitioning to daughter cells, and all of these proteins must be imported into the organelle. Translocase of the outer membrane (TOM) and translocase of the inner membrane (TIM) mediate the import of proteins into the mitochondrion. The translocase of the outer membrane (TOM) sorts proteins via several mechanisms either directly to the outer membrane, the intermembrane space, or the translocase of the inner membrane (TIM). Then, generally, the TIM23 machinery mediates protein translocation into the matrix and the TIM22 machinery mediates insertion into the inner membrane. Fatty acids import into mitochondria (Carnitine Shuttle System) Carnitine-acylcarnitine translocase (CACT) catalyzes both unidirectional transport of carnitine and carnitine/acylcarnitine exchange in the inner mitochondrial membrane, allowing the import of long-chain fatty acids into the mitochondria where they are oxidized by the β-oxidation pathway. The mitochondrial membrane is impermeable to long-chain fatty acids, hence the need for this translocation.
Sources: en.wikipedia.org
== External links == Official website of Lotte Bjerre Knudsen An unofficial source listing the publications of Knudsen. A formal source of patents issued to Knudsen. The 2022 Danish TV mini-series, "The Story of GLP-1", focused on the work of Knudsen.
Zinc is an efficient Lewis acid, making it a useful catalytic agent in hydroxylation and other enzymatic reactions. The metal also has a flexible coordination geometry, which allows proteins using it to rapidly shift conformations to perform biological reactions. Two examples of zinc-containing enzymes are carbonic anhydrase and carboxypeptidase, which are vital to the processes of carbon dioxide (CO2) regulation and digestion of proteins, respectively. In vertebrate blood, carbonic anhydrase converts CO2 into bicarbonate and the same enzyme transforms the bicarbonate back into CO2 for exhalation through the lungs. Without this enzyme, this conversion would occur about one million times slower at the normal blood pH of 7 or would require a pH of 10 or more. The non-related β-carbonic anhydrase is required in plants for leaf formation, the synthesis of indole acetic acid (auxin) and alcoholic fermentation. Carboxypeptidase cleaves peptide linkages during digestion of proteins. A coordinate covalent bond is formed between the terminal peptide and a C=O group attached to zinc, which gives the carbon a positive charge. This helps to create a hydrophobic pocket on the enzyme near the zinc, which attracts the non-polar part of the protein being digested.
The Moscow Jewelry Factory and the Jewellerprom produce jewelry. Other industries are located just outside Moscow, and some microelectronic industries are located in Zelenograd, including the company Ruselectronics. Gazprom, the world's largest extractor of natural gas and the largest Russian company, is headquartered in Moscow, along with other oil, gas, and electricity companies. Moscow contains the headquarters of many telecommunications and technology companies, including 1C, ABBYY, Beeline, Kaspersky Lab, Mail.Ru Group, MegaFon, MTS, Rambler&Co, Rostelecom, Yandex, and Yota. Some industry is being transferred out of Moscow to improve the city's ecological condition.
Sources: en.wikipedia.org
Not necessarily. TB-500 is a commercial label that suppliers apply to synthetic peptides described as thymosin beta-4 or a fragment of it. Published research most often studies the full-length protein, so statements about one do not automatically transfer to the other.
No. No major regulatory authority lists an approved product under this name, and no pharmacopoeial monograph exists for it. Material sold under the label is therefore supplied outside approved pharmaceutical channels, which affects the quality documentation available.
It falls within a prohibited class covering peptide hormones and growth factors, based on presumed effects on tissue repair and blood vessel formation. Anti-doping laboratories have published mass spectrometry methods for detecting thymosin beta-4 related peptides in urine samples.
Divide it into single-use aliquots and hold them frozen at -20 °C or below, protected from light. Repeated thawing of one container is the main avoidable source of variability.